The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.
The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.
1. ADL-MAX Placement. You must Place the ADL-MAX on a flat surface with less than 1/16 inch sag.
Placing the ADL-MAX on an uneven surface may result in picking problems from the Disc Publisher printer tray.
If the ADL-MAX is on a flat surface try recalibrating the ADL-MAX to the Disc Publisher printing tray (see related article below) or try the following:
2. Manual Calibration of Pick Depth
1. Place one disc in the front bin on the left side of the ADL-MAX.
2. Hold the Pick and Sequence buttons until the lights flash.
3. While the lights are flashing push the Pick button.
4. Press the Pause or Sequence button 5 times. You will hear the picker click each time.
---Pressing Pause causes the unit to pick lighter. (If it is picking too deep, the tray will bend slightly as it picks.)
---Pressing Sequence causes the unit to pick deeper.
5. Press the Pick button to set the new pick depth.
Important Note: Even though this calibration is done for only one bin it will affect all ADL-MAX picking postions including the printer tray of the Disc Publisher.
Related Articles:
How do I calibrate the ADL-MAX bins. How do I re-calibrate the Disc Publisher tray and drive(s) to the ADL-MAX.
Related Articles
PTPublisher for Mac: How to calibrate printer and drive picking depth positions for a Disc Publisher. Fix Error: Multiple discs were placed in the printer or drive tray
1. Open Ptpublisher. 2. Once open at the top next to the apple logo select Ptpublisher then select Calibrate robot... 3. Click Calibrate Disc in Printer if you are getting an error that multiple discs were placed in the printer tray but only one was ...How do I calibrate the ADL-MAX bins? How do I re-calibrate the Disc Publisher tray and drive(s) to the ADL-MAX?
How do I calibrate the ADL-MAX bins? How do I re-calibrate the Disc Publisher tray and drive(s) to the ADL-MAX? The first time you open the PrimoDVD or RoboPrint software you will be prompted to calibrate the ADL-MAX to the Disc Publisher. The pick ...My Composer Max is not picking discs or is dropping discs. (Calibration Instructions)
My Composer Max is not picking discs or is dropping discs. (Calibration Instructions) Use the instructions below and the three buttons on the front of the ComposerMax to calibrate the picking position of the arm. Note: For best results connect the ...The computer or the Disc Publisher does not recognize that the ADL-MAX is connected. The ADL-MAX is not being used even though it is connected.
The computer or the Disc Publisher does not recognize that the ADL-MAX is connected. The ADL-MAX is not being used even though it is connected. Two components need to be installed in order to use the ADL-MAX with a Disc Publisher. 1. ADL-MAX ...When I press the ink cartridge button to load cartridges the printer tray ejects. How do I change cartridges? (ADL-MAX)
When I press the ink cartridge button to load cartridges the printer tray ejects. How do I change cartridges? (ADL-MAX) When the ADL-MAX is connected, a disable lid sensor command is sent to the Disc Publisher. This causes the buttons to function ...