PTPublisher for Mac: How to calibrate printer and drive picking depth positions for a Disc Publisher. Fix Error: Multiple discs were placed in the printer or drive tray

1. Open Ptpublisher.

2. Once open at the top next to the apple logo select Ptpublisher then select Calibrate robot...

3. Click Calibrate Disc in Printer if you are getting an error that multiple discs were placed in the printer tray but only one was placed there.

4. Place disc in printer then Click "OK".

5. The printer tray will then be calibrated.

Note: You can also perform calibrations for the Top and Bottom drives if you are getting multiple disc placed errors in either of those locations. 

Article ID: 112219

• Related Articles

• How do I calibrate the ADL-MAX bins? How do I re-calibrate the Disc Publisher tray and drive(s) to the ADL-MAX?

    How do I calibrate the ADL-MAX bins? How do I re-calibrate the Disc Publisher tray and drive(s) to the ADL-MAX? The first time you open the PrimoDVD or RoboPrint software you will be prompted to calibrate the ADL-MAX to the Disc Publisher. The pick ...

• The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.

    The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc. 1. ADL-MAX Placement. You must Place the ADL-MAX on a flat surface with less than 1/16 inch sag. Placing the ADL-MAX on an uneven surface may result in ...

• Error - multiple discs have been placed in the recorder or printer but they were not - Problems picking last disc from bin - It says it is empty but it is not - After the last disc is picked, a flashing cartridge light is displayed after checking for a double pick.

  For BravoPro Xi, 4100 or 4200 Series Only: 1. In PTPublisher, Go to the Tools Menu - Calibrate the Disc Publisher. (For Mac: Go to the PTPublisher Menu - Calibrate Robot) 2. Find the "Other Calibrations" section at the bottom. 3. If the error ...

• My Bravo (SE, SE-3, II, XR, XRP, Pro, Xi-Series, 4100, 4200 Series) is not picking discs or is dropping discs?

  Where and How is it failing? First, determine exactly where and how the robot is failing to pick. To do this, operate the unit with the cover open. You will need to trick the lid sensor into believing the unit's cover is still closed. Follow this ...

• My Composer Max is not picking discs or is dropping discs. (Calibration Instructions)

  My Composer Max is not picking discs or is dropping discs. (Calibration Instructions) Use the instructions below and the three buttons on the front of the ComposerMax to calibrate the picking position of the arm. Note: For best results connect the ...