Error - multiple discs have been placed in the recorder or printer but they were not - Problems picking last disc from bin - It says it is empty but it is not - After the last disc is picked, a flashing cartridge light is displayed after checking for a double pick.
For BravoPro Xi, 4100 or 4200 Series Only:
1. In PTPublisher, Go to the Tools Menu - Calibrate the Disc Publisher. (For Mac: Go to the PTPublisher Menu - Calibrate Robot)
2. Find the "Other Calibrations" section at the bottom.
3. If the error occurred after the disc was placed in the printer, click "Calibrate Disc in Printer"
4. If the error occurred after the disc was placed in one of the drives, click "Calibrate Disc in Top Drive" or "Calibrate Disc in Bottom Drive".
5. If you are unsure where the last disc placement was, perform all three calibrations in steps 3 and 4.
Note: Calibrate last Disc is only used to increase the accuracy of the disc bin counts and fix problems switching between bins in kiosk mode. The 4100, 4200 series and the Xi have advanced double pick detection that requires these special calibrations described above.
For all other Bravo Printers:
1. In PTPublisher, Go to the Tools Menu - Calibrate the Disc Publisher. (For Mac: Go to the PTPublisher Menu - Calibrate Robot)
2. Find the "Other Calibrations" section at the bottom.
3. Click Calibrate last Disc.
For Mac OS 10.5 or older use these stand alone calibration utilities.
| Bravo II/XR - MAC | Download Calibration Instructions and Utility | BravoPro - MAC | Download Calibration Instruction and Utility | ||
Related Articles
The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing.
Article # 207963 - The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing. To fix this issue, Run the Calibrate Last Disc (PC) or ...PTPublisher for Mac: How to calibrate printer and drive picking depth positions for a Disc Publisher. Fix Error: Multiple discs were placed in the printer or drive tray
1. Open Ptpublisher. 2. Once open at the top next to the apple logo select Ptpublisher then select Calibrate robot... 3. Click Calibrate Disc in Printer if you are getting an error that multiple discs were placed in the printer tray but only one was ...LX3000 - Empty Ink Error but Ink is not Empty. PrintHub Software or Mac Config Utility says my ink tanks are empty but I can see there is still ink left.
Error explanation: Ink usage is calculated by the software, not a physical sensor(gas gauge). Between printer uses, some ink bleeds out of the ink lines and back into the tank. When you start printing again, it takes some time for the ink to make its ...The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc.
The ADL-MAX is not picking discs from the printer tray after the Disc Publisher prints a disc. 1. ADL-MAX Placement. You must Place the ADL-MAX on a flat surface with less than 1/16 inch sag. Placing the ADL-MAX on an uneven surface may result in ...My Bravo (SE, SE-3, II, XR, XRP, Pro, Xi-Series, 4100, 4200 Series) is not picking discs or is dropping discs?
Where and How is it failing? First, determine exactly where and how the robot is failing to pick. To do this, operate the unit with the cover open. You will need to trick the lid sensor into believing the unit's cover is still closed. Follow this ...