Labels are not applied to lip balm, chap stick or small diameter containers. The label either goes over the container or pushes the container off the rollers. (AP360/AP362)
Since these containers are so small they can be challenging to apply labels to. They are within the applicator specifications but they work best with certain label stock.
Tips:
- More Pressure. Rest your hand on top of the container pressure arm as you are applying labels.
- Half-Speed Mode. Enable half-speed mode.
- More Diameter. Add more diameter to the container pressure arm roller by wrapping it with as much tape as the arm bracket will allow. This will give the arm more pressure.
- Core Memory. Any curve of the label coming off the roll can cause it to go over the container instead of under it. Reduce the curve of the label coming off the roll. See the tips below:
- Use a new roll or a larger roll of labels. Labels have more and more curve the closer you get to the core of the stock. They "remember" that curve went they come off the roll.
- The older the roll and the longer the labels have been on the core the more memory they will have. Use a new roll that was recently converted/cut.
- Certain types of label stock material have more or less curve memory. Often thicker paper stock will come off the roll with less curve. However, paper labels tend to work better than synthetic labels like Polyester, Vinyl, or BOPP. Try different label stock.
- Attach a hold-down stick to the container pressure arm. Use two - one on either side of the arm. The stick could be made of plastic, wood, or metal. To minimize the chance of the label sticking to the stick, the tip should be as round and smooth as possible. (Example: cotton swab stick, coffee stir stick, any rounded metal rod such as a screwdriver). Tip: Glue a strong magnet to the metal/plastic rod so the stick is more easily adjustable and removable.
- Reroll the label stock upside down (top of label facing inward) onto a new core to counteract curve. Leave the rolls in the upside-down state for as long as possible. When you are ready to use them, reroll it again with the labels facing out. Follow this procedure to reroll the labels.
Article ID: 070822
Related Articles
Can I use containers with a lip or a lid on the top which sticks out further than the container? (AP360-AP362-AP380).
The AP360/362/380 has a notch in the container drive roller and container idler roller. This notch is intended to accommodate a lip or lid that sticks out at the top of the container. That lip/lid cannot extend more than 3mm from the rest of the ...Labels are not sticking to the containers. The label adhesive is lifting off the containers some time after application.
If your label does not stick to the container immediately or lifts off after some time, consider these solutions: Label Stock Adhesive. All of Primera's label stock has Acrylic based adhesive. Most of it has the same adhesive strength. Each label ...Labels are applied to the container crooked. (AP360-AP362-AP380)
1. Proper Setup. Please follow all of the setup steps in the Manual or the Setup Video. 2. Check for Container Taper. Some containers such as wine bottles may have a slight taper that will cause the label to be applied crooked. You may be able to ...My labels have bubbles or wrinkles. How can I resolve this? AP360/AP362/AP380
This issue can be caused by one of the following: 1. The container is not completely round, not smooth or has bumps or ridges. See this article on tapered containers. 2. The labels are applied crooked due to incorrect setup. See this article. 3. The ...The AP-Code Date Coder is not printing. Status is Ready, the container moves, the label is applied but nothing is printed.
1. Ensure the Roller Track Wheel is installed properly so that it touches the liner drive roller. Watch the Printer Status screen. When you press the foot switch, the Printer State should change to "Printing". If the status remains on Ready, it means ...