The Lamination Mode Setting is Missing from Print Hub for my LX610.
The lamination mode setting is available on the Printer Settings Tab in Advanced Settings. Scroll to the bottom to find it.
If it is not visible, try the following:
A. Restart Print Hub.
1. Close Print Hub.
2. Power ON the LX610.
3. Open Print Hub with the LX610 powered on.
Note: Print Hub checks the version of the firmware at start-up and only displays the option if the LX610 is updated past a certain version. If the firmware has not been updated past version 1.44 or the LX610 is not powered on, the Lamination Mode option will not appear.
Article ID: 020224
Related Articles
How do I use Lamination Mode on the LX610?
Enable "Lamination Mode" in PrintHub and Config Utility (Coming Soon to Mac). This setting will convert Matte BOPP or Gloss BOPP digital die-cut material into waterproof labels. With lamination, Premium Gloss stock will become highly ...
What is Continuous Media? What is Continuous Sensor Mode (LX Label Printers)
Continuous Media is label stock that has no black mark, die-cut, or through-hole. When ordering custom label stock, you may select the continuous check box. However, this is not a typical option to select. Only the width applies to continuous ...
The LX3000/LX4000 Print Head is printing with Poor Quality, Banding, Streaks, or Missing Colors.
You may need to replace your print head. The nozzles can wear out over time. Tip! Leave the printer powered on when it is not in use to maintain cartridge readiness! 1. Clean / Test Print. Print the Clean/Test Print described in this article. Send us ...
What size/type cookies can I print to with my Eddie?
The cookie size and shape you can print depends on whether or not you are using the carousel and other settings. You have more flexibility in Manual Mode/Single Cookie mode. There are several modes available. See the specifications for each below. 1. ...
LX3000 - Empty Ink Error but Ink is not Empty. PrintHub Software or Mac Config Utility says my ink tanks are empty but I can see there is still ink left.
Error explanation: Ink usage is calculated by the software, not a physical sensor(gas gauge). Between printer uses, some ink bleeds out of the ink lines and back into the tank. When you start printing again, it takes some time for the ink to make its ...