How to adjust cross cutter offset in Print Hub for LX610.

1. Update to the latest version of Print Hub.  Follow this article.

2. Digital Die Cut Mode: To adjust the cross cut offset in digital die cut mode, insert digital die cut media (with a smart chip) and then go to XY Cutter tab that appears.

3. Pre die-cut mode: To adjust the cross cut offset with pre die cut label stock, (no smart chip, blank green hub installed) go to the print alignment tab.  Adjust Cut Position.

Article ID: 111324

• Related Articles

• Can I use the output cross cutter to cut the final height of my labels? (LX500, LX600, LX610, LX910, LX2000, LX3000)

  Using the output cutter to cut the height of the label is not recommended. The output cutter was designed to cut a printed section of labels from the printer after it is complete.  It typically cuts through liner only in the gaps between the labels.  ...

• Labels are printing horizontally offset (left to right) on an LX Series printer. The image alignment is printing too far to the left or right. There is white space on the right or left side of my label.

  If your labels are printing consistently offset in one direction or if the offset gradually changes from one label to the next, this article applies to you. For sudden changes in the horizontal offset, follow this article. 1. Label Loaded ...

• How do I use the Cleaning Card to clean my output cross-cut media cutter. (LX600, LX610, LX910, LX3000, LX500)

  Video Demonstration https://youtu.be/0ibFKY52kho PC Instructions Note: This cleaning procedure works best when done regularly. If your cutter gets too full of adhesive and other debris, it may need more through cleaning. Follow these articles: LX600, ...

• Cutter Stall Error (LX600-LX610)

  The cutter referred to by this error message is the output cutter located at the front of the printer. This is a pizza wheel-style cutting disc that completely cuts through the label/media at the end of the job or at the end of every page, depending ...

• How do I move a cut closer or further away from the printed image? How do I create a bleed cut or create an outline cut? Inset Offset Path (LX610).

  Using PTCreate or PTCreate Pro you can either create an outline around your image (offset path) or you can create a bleed around your label to make it easier to cut the shape without leaving any white space (inset offset). 1. With the cut line ...