How can I print on the far left side of the container using AP-Code with my AP360/AP362 applicator.
The normal print area range of the AP-Code does not allow for printing on the far left side of the container. Typically we would recommend changing the orientation of the your label stock so that you can change the orientation of your container. Rerolling the label stock onto another core will change the orientation.
However, if it is not possible to reroll label stock, follow these instructions:
1. Disconnect the HDMI Cable and remove the print head carrier from the container pressure arm and swap the orientation.
2. Use a longer HDMI cable. Primera does not sell these cables. However, any HDMI Cable will work. Ideally, use a cable with a right-angle plug so you can more easily route it away from the label stock. Example: https://www.amazon.com/GELRHONR-Gold-Plated-Connector-Ethernet-Projector-Black/dp/B0B174Q781
3. Change the orientation by touching the Tt icon on the tablet.
Important Note: Currently, the date is printed mirrored which makes this process unfeasible. A future AP-code update will address this issue.
Article ID: 051623
Related Articles
How should I store the cartridge for my AP-Code Date coder when it is not being used?
To prevent ink evaporation, when the cartridges is not being used, you should remove it from the printer, cap it using the included cartridge garage and store it in the zip-locked foil bag that it came with. For best results, follow this procedure ...Labels are printing horizontally offset (left to right) on an LX Series printer. The image alignment is printing too far to the left or right. There is white space on the right or left side of my label.
If your labels are printing consistently offset in one direction or if the offset gradually changes from one label to the next, this article applies to you. For sudden changes in the horizontal offset, follow this article. 1. Label Loaded ...The AP-Code Date Coder is not printing. Status is Ready, the container moves, the label is applied but nothing is printed.
1. Ensure the Roller Track Wheel is installed properly so that it touches the liner drive roller. Watch the Printer Status screen. When you press the foot switch, the Printer State should change to "Printing". If the status remains on Ready, it means ...AP-Code Date Coder display does not start up normally.
1. Startup Menu Displayed. If your AP-Code Date Coders tablet powers on, but shows a startup menu instead of starting up, check to ensure that the volume rocker located at the bottom of the tablet isn't making contact with the tablet's stand. Pushing ...The LX3000/LX4000 Print Head is printing with Poor Quality, Banding, Streaks, or Missing Colors.
You may need to replace your print head. The nozzles can wear out over time. Tip! Leave the printer powered on when it is not in use to maintain cartridge readiness! 1. Clean / Test Print. Print the Clean/Test Print described in this article. Send us ...