Can I apply labels to a tapered container (AP360-AP362)
Applying labels to tapered containers by angling the container idler roller at the front of the machine is possible. Containers with a
5°-or-less taper per side have a chance of applying labels square to the
container using an AP360/362 with the idler roller offset by one notch.
How well it works depends on the exact angle of the taper combined with
the diameter of the container. These two variables are interdependent, so
any container in question would have to be tested on an actual unit. Primera can test your container and labels before you make a purchase decision.
Notes:
- You must use labels that include a curved top, and bottom edge. It should also be shaped like a trapezoid (Wider/Narrower at the top vs. the bottom). This will allow you to apply the label straight with no wrinkles or bubbles. Provide your label converter with the specifications of your container. With this information, they will be able to create a label that fits your container.
- Adjust the Container Idler Roller per the instructions below. There are pre-established notches that can be used to angle the container idler roller so that the container is level. However, for best results, you should clamp the roller into the optimal position.
Use these instructions to adjust the container idler roller.
Related Articles
My labels have bubbles or wrinkles. How can I resolve this? AP360/AP362
This issue can be caused by one of the following: 1. The container is not completely round, not smooth or has bumps or ridges. See this article on tapered containers. 2. The labels are applied crooked due to incorrect setup. See this article. 3. ...How to create labels for my tapered container (LX Series Label Printers)
Tapered containers are a challenge because a standard rectangular label does not look right when applied to the container and can be difficult to apply without bubbles. Full wrap-around labels for tapered containers usually have a curve (arc) on the ...Labels are applied to the container crooked. (AP360-AP362)
1. Proper Setup. Please follow all of the setup steps in the Manual or the Setup Video. 2. Check for Container Taper. Some containers such as wine bottles may have a slight taper that will cause the label to be applied crooked. You may be able to ...Will my clear labels with clear liner work with the AP360/AP362 or the AP550?
AP360 - AP362 uses a physical flag sensor to detect gaps between labels. The AP360/362 will work with Clear labels with a clear PET liner in most cases as long as the liner and the label are not too thin and the adhesive isn't too strong. The danger ...How can I apply a label starting at a specific point on the container? (AP362 ONLY!)
How can I apply a label starting at a specific point on the container? (AP362 ONLY!) On units with serial numbers greater than 2091000131 you can change the mode of the container roller using the instructions below. Set the Mode of the Container ...