The pause light is flashing when the LX800 starts.

• Related Articles

• The pause light on the LX800/LX810/LX900 starts flashing when I try to print. I receive the message "It appears the label stock may be empty."

  The pause light on the LX800/LX810/LX900 starts flashing when I try to print. I receive the message "It appears the label stock may be empty." If you receive this message, or you see this flashing light indicator you may be out of label stock or ...

• After each disc that I laminate, the Power light starts flashing. If I open and close the cover, I can laminate another disc but the power light starts flashing again.

  After each disc that I laminate, the Power light starts flashing.  If I open and close the cover, I can laminate another disc but the power light starts flashing again. There may be a problem with the laminate film or the sensor.  Try a new roll of ...

• Labels are fed through the printer 24 inches at a time resulting in a flashing pause LED light. (LX800/810)

  Labels are fed through the printer 24 inches at a time resulting in a flashing pause LED light. (LX800/810) The LX800/810 is not properly sensing your label stock.  Check the following settings: SENSOR TYPE SETTING. Make sure the sensor type setting ...

• The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing.

    Article # 207963 - The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing. To fix this issue, Run the Calibrate Last Disc (PC) or ...

• Simultaneous Flashing Pause and Ink Lights. Printer will not print. (LX3000).

  This flashing light sequence (shown below) indicates a missing ink tank or print head. If the ink tank or print head is installed try the following solutions. 1. Update PrintHub/Config Utility and Firmware to resolve this issue. HC11 firmware should ...