The LX800 continuously resets (LEDs are flashing) when it is powered on.

• Related Articles

• Continuous rotating fast flashing lights appear when the unit is powered on. (LX800-810)

    Continuous rotating fast flashing lights appear when the unit is powered on.  (LX800-810) The sequence below is normal while the unit is starting up. This takes approximately 30 seconds. If you have the following flashing light sequence that ...

• LX 2000/ LX 1000 - Error Message: failed printhead, printfailure impropershutdown

  LX2000 - Error Message: failed printhead, print failure improper shutdown Solution 1: Perform a print head alignment described below.   This will clear and resolve the mentioned error message and allow you to print.  Solution 2: Install a new print ...

• Continuous alternating fast flashing lights appear when the unit is powered on. (BravoPro-XRP)

    Continuous alternating fast flashing lights appear when the unit is powered on. You may have a defective cartridge. Try the following: 1. Remove both the color and the black cartridge. 2. Power off the unit. 3. Power on the unit with no cartridges ...

• LX Series Printer prints a partial label and restarts/resets in the middle of a job. (LX910, LX3000)

  Sometimes the printer will restart if it encounters an error or an interruption in the data flow from the computer over the USB cable. It can be hard to realize that the printer is restarting if you don't see it happen. Instead at the end of the job, ...

• No Response. Make sure the Disc Publisher is powered on and the USB cable is connected.

   No Response.  Make sure the Disc Publisher is powered on and the USB cable is connected. There are several things to check. 1. Local Admin Rights. You must be have local administrative rights to the PC running the Bravo.  You may be able to print ...