The last few labels of my roll are wasted. Out of Paper error is displayed but there are still labels remaining. Is there any way to print on the last labels of the roll. (LX600, LX610, LX900, LX910, LX2000, LX1000, IP60)
By design the last 12-18” will
be wasted because the printer no longer detects a loop under the roll, or the chip on the LX600/610/ip60 detects the end of the roll. We must stop before the
last labels are fed through to prevent the tape or strong adhesive attaching the labels to the core from feeding through the printer and
getting stuck. Also, the last few labels would also not be properly aligned because
there would be no roll to help guide them straight.
Important Note about the LX610 and Catalyst Digital Die Cut Rolls: For the LX610, each digital die-cut roll has a chip programmed to stop after 150, 125 or 100 feet depending on the media type. The supplier adds extra material to each roll to ensure customers get all they paid for and prevent the issues described above. Each roll can have between 2-10 feet of extra material. Sometimes, the roll may have even more stock remaining if the label supplier makes a mistake. The outer diameter of LX610 digital die cut rolls should be 5.75". The outer diameter of standard pre-die cut rolls is 6". If the supplier failed to adjust their counter, the digital die-cut rolls would have more stock than they should. Rest assured, as long as your roll is 5.75" OD you have all of the label stock you have paid for.
Important Note about IP60 Photo Rolls: Each roll has a chip programmed to stop after 175 feet (except magnetic - 100 feet). The supplier adds extra material to each roll to ensure customers get all they paid for and prevent the issues described above. Each roll can have between 2-10 feet of extra material. Sometimes, the roll may have even more stock remaining if the label supplier makes a mistake. The outer diameter should be 6.00". Rest assured, as long as your roll is 6.00" OD you have at least 175 feet of label stock.
Article ID: 063020
Related Articles
Paper Out Error is displayed in PrintHub (LX610).
Normally, the paper out error indicates that you are at the end of a roll of label stock. You will need to load another roll of media in the printer. If the media is loaded, and the error appears when you send at print, or the error appears at ...
Receive error out of paper or end of roll but there are still labels on the core. (LX900-LX810)
Receive error out of paper or end of roll but there are still labels on the core. (LX900-LX810) 1. Labels on the roll may be sticking together. This may prevent the printer from creating a slack loop under the roll. Try a new roll of stock. 2. ...
The top surface of the label stock has left over adhesive residue causing feeding issues from the roll (LX900, LX910, LX2000, LX3000).
Occasionally excess adhesive can ooze out from under the label stock, especially if the roll is wrapped tightly. This can prevent the labels from falling off the back of the roll, creating a slack loop that is essential for proper feeding on the LX ...
After printing a Gap Sensing Error, Non Digital Die-Cut Error or Failed to find the next label Error (Mac) is displayed. The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12".
When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...
LX3000 - Empty Ink Error but Ink is not Empty. PrintHub Software or Mac Config Utility says my ink tanks are empty but I can see there is still ink left.
Error explanation: Ink usage is calculated by the software, not a physical sensor(gas gauge). Between printer uses, some ink bleeds out of the ink lines and back into the tank. When you start printing again, it takes some time for the ink to make its ...