The laminate is not covering the entire disc.

The laminate is not covering the entire disc.

Heat. Try increasing the heat via the temperature slide bar.

Ink. If you are printing discs with heavily saturated dark or black areas you may need to wait several minutes to several hours before laminating depending on the media type. If you laminate immediately after printing it is possible that the laminate will not adhere to the wet areas of the disc.

Media. Certain media absorbs the ink more quickly and more completely than others. Try different media or Accent Certified media kits available from www.primerastore.com.

Tray Speed. Adjust the tray speed using the instructions in this article.

Article ID: 44816

Related Articles
After each disc that I laminate, the Power light starts flashing. If I open and close the cover, I can laminate another disc but the power light starts flashing again.
After each disc that I laminate, the Power light starts flashing. If I open and close the cover, I can laminate another disc but the power light starts flashing again. There may be a problem with the laminate film or the sensor. Try a new roll of ...
The ADL-100 is not working with my Accent II. When I press "Laminate" the ADL-100 does not pick a disc.
The ADL-100 is not working with my Accent II. When I press "Laminate" the ADL-100 does not pick a disc. 1. Make sure the 6-pin mini-din cable is connected to both the Autoloader and the Accent II. 2. Make sure the laminate is loaded. 3. Try a new ...
How do I use Lamination Mode on the LX610?
Enable "Lamination Mode" in PrintHub and Config Utility (Coming Soon to Mac). This setting will convert Matte BOPP or Gloss BOPP digital die-cut material into waterproof labels. With lamination, Premium Gloss stock will become highly ...
PTPublisher for Mac: How to calibrate printer and drive picking depth positions for a Disc Publisher. Fix Error: Multiple discs were placed in the printer or drive tray
1. Open Ptpublisher. 2. Once open at the top next to the apple logo select Ptpublisher then select Calibrate robot... 3. Click Calibrate Disc in Printer if you are getting an error that multiple discs were placed in the printer tray but only one was ...
There is a disc stuck in my drive. My CD/DVD Drive is making unusual noises whenever I attempt to burn a disc. The disc is rejected or the software locks up.
There is a disc stuck in my drive. My CD/DVD Drive is making unusual noises whenever I attempt to burn a disc. The disc is rejected or the software locks up. Problem: Check for a clear disc stuck in the recorder. Clear discs are typically put in the ...

The laminate is not covering the entire disc.

The laminate is not covering the entire disc.

Related Articles

After each disc that I laminate, the Power light starts flashing. If I open and close the cover, I can laminate another disc but the power light starts flashing again.

The ADL-100 is not working with my Accent II. When I press "Laminate" the ADL-100 does not pick a disc.

How do I use Lamination Mode on the LX610?

PTPublisher for Mac: How to calibrate printer and drive picking depth positions for a Disc Publisher. Fix Error: Multiple discs were placed in the printer or drive tray

There is a disc stuck in my drive. My CD/DVD Drive is making unusual noises whenever I attempt to burn a disc. The disc is rejected or the software locks up.