The Composer or Conductor makes a grinding noise when it is turned on or when the arm starts moving down.
The Composer or Conductor makes a grinding noise when it is turned on or when the arm starts moving down.
Solution:
Make sure the correct power supply is plugged in. If the 30v power supply for a Signature printer is plugged into the Composer it will cause a grinding noise as soon as it is plugged in or when the arm starts moving down.
The Composer or Conductor use a 24v power supply. See this article for complete specs.
Article ID: 45059
Related Articles
The arm for my Bravo / Bravo II / Bravo Pro is stuck in the up or down position. It makes a buzzing noise when I power on the unit. (inhouse)
The arm for my Bravo / Bravo II / Bravo Pro is stuck in the up or down position. It makes a buzzing noise when I power on the unit. Bravo II This can happen if the Bravo II power is interrupted during an arm movement. Use the following procedure to ...
My printer is making a shaky, grinding, juddering, squeaking sound while printing. What can I do? (Eddie, LX600, LX610, LX910, LX3000)
You may need to tighten your carrier belt. Watch the video below for instructions. https://youtu.be/uP5qzNxxRts Article ID: 101421
The printer tray does not eject when the Composer arm tries to load a disc.
Make sure the 6 pin din round auxiliary cable is connected from the back of the printer to the back of the Composer.Article ID: 44665
My Composer Max is not picking discs or is dropping discs. (Calibration Instructions)
My Composer Max is not picking discs or is dropping discs. (Calibration Instructions) Use the instructions below and the three buttons on the front of the ComposerMax to calibrate the picking position of the arm. Note: For best results connect the ...
The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing.
Article # 207963 - The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing. To fix this issue, Run the Calibrate Last Disc (PC) or ...