The Bravo / Bravo II will not stay powered on. When it is plugged in it performs initialization and then powers off.
The Bravo / Bravo II will not stay powered on. When it is plugged in it performs initialization and then powers off.
This can sometimes be caused by a faulty print cartridge. Try the following procedure:
1. Remove both cartridges. Since the unit does not stay powered on you will need to manually remove the cartridges. It may be necessary to unhook the cartridges from the arm. There is a small release tab on the arm above the cartridges that will allow you to accomplish this.
2. Unplug power, USB and Firewire (if applicable).
3. Plug in just the power cord with no cartridges installed. Check to see if the unit stays powered on. If so, attempt to replace the cartridges. Now unplug and plug in the power cord. Check to see if it stays powered on with the same cartridges installed.
- If it does not stay powered on with the same cartridges installed, you may have defective cartridges - Replace the cartridges.
- If it does not stay powered on with no cartridges installed, you may have a defective print carriage - Contact tech support for repair procedures.
Article ID: 44766
Related Articles
The Bravo/Bravo II is not staying powered on. It turns off after initialization.
The Bravo/Bravo II is not staying powered on. It turns off after initialization. This can be caused by a faulty color or black cartridge. Replace one or both cartridges, unplug power and restart the unit. Contact Tech Support for replacements of ...
My image is not printing centered on my discs (Bravo Disc Publisher Series - PTPublisher)
This may be due to: 1. Ink on the Print Tray. Clean any excess ink that has accumulated on the printer tray with rubbing alcohol and a paper towel. Ink can cause the disc to stick on the tray and NOT slide into the correct position for printing. This ...
The power light is flickering/flashing whenever I try to print or when the unit is first turned on. The printer will not print. (Bravo, Bravo II, Bravo XR, Signature)
The power light is flickering/flashing whenever I try to print or when the unit is first turned on. The printer will not print. (Bravo, Bravo II, Bravo XR, Signature) The blinking power light indicates that the unit has a cartridge problem. There ...
When both the Bravo XR and Bravo II drivers are installed the Bravo XR will not print through Discribe. (Mac Only)
When both the Bravo XR and Bravo II drivers are installed the Bravo XR will not print through Discribe. (Mac Only) Both of these printer drivers cannot be installed at the same time if you are printing and burning through Discribe. You must remove ...
Which USB 2.0 and Firewire Cards does Primera recommend to connect to the Bravo, Bravo II or BravoPro?
Which USB 2.0 and Firewire Cards does Primera recommend to connect to the Bravo, Bravo II or BravoPro? We recommend the cards that we sell through our sales number - 1-800-797-2772. However, the most important part of a card is not the brand but ...