Receive error out of paper or end of roll but there are still labels on the core. (LX900-LX810)
Receive error out of paper or end of roll but there are still labels on the core. (LX900-LX810)
1. Labels on the roll may be sticking together. This may prevent the printer from creating a slack loop under the roll. Try a new roll of stock.
2. The loop sensor may need recalibration. Try the following procedure:
a. Remove the label stock from the printer.
b. Turn off the printer.
c. Press and hold the Feed button as you turn on the printer.
d. Release the Feed button after a few seconds. Resume printing.
Article ID: 44812
Related Articles
The last few labels of my roll are wasted. Out of Paper error is displayed but there are still labels remaining. Is there any way to print on the last labels of the roll. (LX600, LX610, LX900, LX910, LX2000, LX1000, IP60)
By design the last 12-18” will be wasted because the printer no longer detects a loop under the roll, or the chip on the LX600/610/ip60 detects the end of the roll. We must stop before the last labels are fed through to prevent the tape or strong ...
Paper Out Error is displayed in PrintHub (LX610).
Normally, the paper out error indicates that you are at the end of a roll of label stock. You will need to load another roll of media in the printer. If the media is loaded, and the error appears when you send at print, or the error appears at ...
The top surface of the label stock has left over adhesive residue causing feeding issues from the roll (LX900, LX910, LX2000, LX3000).
Occasionally excess adhesive can ooze out from under the label stock, especially if the roll is wrapped tightly. This can prevent the labels from falling off the back of the roll, creating a slack loop that is essential for proper feeding on the LX ...
My label printers skips labels between prints, feeds out blank labels or is printing over the same place. (LX500, LX600, LX610, LX910, LX2000, LX3000).
The printer will skip one label before printing for the first time after loading a new roll of label stock. This is to prevent jamming of labels and cannot be disabled. The printer should not skip labels between consecutive print jobs. If the printer ...
The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12". When the print is sent, Gap Sensing Error is displayed or Non Digital Die-Cut Error message is displayed
When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...