Print Head Failed error message is displayed in the status monitor. (LX2000)
Print Head Failed message can be a temporary condition. Follow these instructions:
- Remove the Print Head.
- Power off the printer.
- Wait 1 minute (This is necessary for all internal capacitors to discharge).
- Clean the copper contacts on the printer and the print head with isopropyl alcohol.
- Turn on the printer without the print head installed.
- Wait for the printer to start up - approximately 1 minute.
- Reinsert the print head.
- Close and Open the front cover several times and watch the status monitor between each closing and opening.
If the problem persists, it could be a worn out print head or a problem with the printer.
A new print head can be purchased on our webstore. Part Number: 053467
Article ID: 88984
Related Articles
LX 2000/ LX 1000 - Error Message: failed printhead, printfailure impropershutdown
LX2000 - Error Message: failed printhead, print failure improper shutdown Solution 1: Perform a print head alignment described below. This will clear and resolve the mentioned error message and allow you to print. Solution 2: Install a new print ...
Filter Failed message appears in print queue. Eddie or LX Series Printer is not printing. Ventura, Catalina, Big Sur, Monterey, Sonoma and Sequoia require new drivers (Mac).
Try these steps in order. 1. Install the latest version. Occasionally, the driver will be corrupted after an OS update. Download the latest version from the products download page. You can find the latest software for your product at the location ...
The LX3000/LX4000 Print Head is printing with Poor Quality, Banding, Streaks, or Missing Colors.
You may need to replace your print head. The nozzles can wear out over time. Tip! Leave the printer powered on when it is not in use to maintain cartridge readiness! 1. Clean / Test Print. Print the Clean/Test Print described in this article. Send us ...
Print Head Jammed error message displayed in PTStatus2000 software (LX2000).
This error means that the print head is stuck over the maintenance cap used to seal the cartridge nozzles on the right side of the printer or anywhere along the carrier path. Try these possible solutions: Remove power from the printer. Disconnect ...
Print Queue- PT Status Monitor says Printing, but there's no activity on the printer. LX400, LX900, LX1000, LX2000 (Windows 10 1903 release)
Windows 10 release 1903 causes these issues. Try the following solutions: 1. Update to the latest version of Windows. Windows 10 release 2004 fixes this issue. Alternatively, you may upgrade your existing version of Windows 1903 or 1909 with a ...