Print Alignment Not Available for Digital Die-Cut message appears on the alignment screen in PrintHub. (LX610 Only)

Print alignment is not available on the LX610 by design because there are no die-cut labels that can be aligned to a print.  Instead, the cut line must be aligned to wherever the printing occurs.  Cut alignment is calibrated at the factory.  However, it is possible that you may need to adjust the cut line position for certain prints/cuts.

To adjust the cut alignment use the nudge tool in PTCreate design software. The nudge arrows can be used to move the cut line very small amounts in any direction. Make sure you have the cutline or cut layer selected before using the nudge arrows.  Note: This may make it appear in the software that the cutline will not be in the correct location.  This is normal since you are compensating for an inaccurate cut position.  As long as the print and cut line up on your label it doesn't matter that the software is offset.

Article ID: 052920

• Related Articles

• The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12". When the print is sent, Gap Sensing Error is displayed or Non Digital Die-Cut Error message is displayed

  When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...

• Cuts do not line up with the prints or alignment is off. Cuts are crooked (LX610).

  Cut alignment is calibrated at the factory. However, it is possible that you may need to adjust the cut line position for certain prints/cuts. 1. Reduce page size in PTCreate as much as possible. For example, if your page contains 2 columns and 4 ...

• What is the difference between Kiss Cut vs Digital Die-cut vs Pre Die-cut? (LX600-LX610-LX910-LX2000-LX500)

• How do I use BarTender 2021 to add cut lines to a print template design (LX610 or Catalyst).

  Within BarTender, any shape can be converted to a cutline that your LX610 or Catalyst printer can cut. You must use BarTender version 2021 Ultralite, Professional, or Enterprise. 1.       Click the shape icon on the toolbar. 2.       Drag the shape ...

• What is the purpose of the Clean and Align buttons in PrintHub? (LX500, LX600, LX610, LX910, LX3000, IP60, Eddie)

  Below is an explanation of the Clean and Align buttons in PrintHub and Config Utility (Mac). Align Button Cartridge alignment fixes quality issues caused by bidirectional misalignment. The alignment print available on all of our printers prints a ...