Paper is coming out of the printer too fast. There is not enough time to tape it to the core. (CX1200)
Paper is coming out of the printer too fast. There is not enough time to tape it to the core. (CX1200)
Make sure the paper type is set to Labels or Custom Type 5. Changing the paper type only affects the speeds of the paper as it travels through the printer. It will not affect quality. No matter what type of stock is loaded, the Paper Type should be set this way.
1. Press the Menu key on the printer's control panel
2. Select the Paper Menu
3. Select Paper Size/Type
4. Select MP Feeder Size/Type
5. Choose "Universal" - Then choose "Custom Type 5" or "Labels"
Note: You may have to press the down arrow repeatedly to view all the options on a particular menu.
Article ID: 44958
Related Articles
Paper Out Error is displayed in PrintHub (LX610).
Normally, the paper out error indicates that you are at the end of a roll of label stock. You will need to load another roll of media in the printer. If the media is loaded, and the error appears when you send at print, or the error appears at ...
Unable to feed paper / media / stock on initial load. Printer will not grab the paper (LX610).
Issue. Wear strip is too thick, too wide or improperly installed which causes it to protrude too high into the paper path. This will prevent the label stock from feeding into the printer. It gets stuck right before the wear strip. If the wear strip ...
The last few labels of my roll are wasted. Out of Paper error is displayed but there are still labels remaining. Is there any way to print on the last labels of the roll. (LX600, LX610, LX900, LX910, LX2000, LX1000, IP60)
By design the last 12-18” will be wasted because the printer no longer detects a loop under the roll, or the chip on the LX600/610/ip60 detects the end of the roll. We must stop before the last labels are fed through to prevent the tape or strong ...
Paper Jam Error 250.15 - MP Feeder Door (CX1200)
Paper Jam Error 250.15 MP Feeder Door (CX1200) A. This error indicates a paper jam at the MP Feeder Door. Please clean the following parts on the door with isopropyl alcohol and a lint-free cloth. (See picture below) Feed Roller (Replacements can ...
“TOF Error” is displayed in the status monitor. Label stock will not load automatically or printer does not detect the label stock. (LX2000).
The LX2000 is not properly sensing the gaps between the labels on your label roll. (TOF = Top of Form) Check the following settings: Try pressing the "Resume/Feed" button on the front of the printer. If the error continues, press the “Cancel” button ...