LX Series Label Printer Video: Re-rolling labels from one core to another.

• Related Articles

• How do I create a label template in Bartender? (LX Series Printer)

  When you open BarTender you will be given the choice to select an existing label or create a new one using a wizard. Use the following instructions as a guide through the wizard setup process. 1. Choose "Start a new BarTender document..." 2.      ...

• How do I Re-roll labels from one core to another?

  You may need to follow this procedure in one of the following scenarios: Your labels were made on the wrong size core. Different Primera printers require different core sizes. The two sizes available are 3" cores and 2" cores. Your labels have a ...

• How do I correctly load the label stock to avoid feeding and printed image alignment offset problems? (LX Series)

  Incorrect loading of the label stock is the number one reason for horizontally or vertically offset images and a variety of other feeding problems. Below is a top view of the printer with the cover open. There are several main areas to watch for when ...

• There is a label stuck or jammed in the feed area of my LX Series label printer. How can I remove it and prevent it from happening again?

  A. Removal: Usually, it is necessary to disassemble part of the printer to remove the stuck label.  This means the unit will need to come to Primera for factory service.  However, there are ways to remove these labels without taking apart the ...

• The top surface of the label stock has left over adhesive residue causing feeding issues from the roll (LX900, LX910, LX2000, LX3000).

  Occasionally excess adhesive can ooze out from under the label stock, especially if the roll is wrapped tightly.   This can prevent the labels from falling off the back of the roll, creating a slack loop that is essential for proper feeding on the LX ...