IP60 Video: Clean or Replace the cutter blade disc
IP60 Video: Clean or Replace the cutter blade disc
The Primera Impressa IP60 can print on a wide variety of materials. If you choose to print on magnetic material the cutting blade that cuts every photo can accumulate waste magnetic material which will eventually prevent proper cutting. Replacement of the blade is usually not necessary. Instead, you can clean it using the procedure in this video. Cleaning the blade will be necessary every 2,000-3,000 cuts when using magnetic material. If you are using other material, you can use this same procedure to clean or replace the blade every 250,000 cuts.
The cutter referred to by this error message is the output cutter located at the front of the printer. This is a pizza wheel-style cutting disc that completely cuts through the label/media at the end of the job or at the end of every page, depending ...
The video below shows the process for the LX2000. However, the mechanism is the same for LX910, LX2000, and LX3000. Tools Required: T10 Torx driver https://www.youtube.com/watch?v=ZlXyeKfg1OQ You may also need to clean the cutter plate with ...
Using the output cutter to cut the height of the label is not recommended. The output cutter was designed to cut a printed section of labels from the printer after it is complete. It typically cuts through liner only in the gaps between the labels. ...
If you are prompted to clean your output cutter using a cleaning card, use these instructions: https://youtu.be/0ibFKY52kho Note: This cleaning procedure works best when done regularly. If your cutter gets too full of adhesive and other debris, it ...
Below is an explanation of the Clean and Align buttons in PrintHub and Config Utility (Mac). Align Button Cartridge alignment fixes quality issues caused by bidirectional misalignment. The alignment print available on all of our printers prints a ...