How do I replace the digital die cutting knife in my LX610?

• Related Articles

• The LX610 goes through the motions of cutting out my label but nothing is cut.

  1. Make sure you have the cutting knife installed. 2. Make sure the cutting knife holder is inserted all the way into the knife collar.  3. Make sure the blue collar release lever is pushed in. 4. The digital die-cutting blade may need replacement. ...

• After printing a Gap Sensing Error, Non Digital Die-Cut Error or Failed to find the next label Error (Mac) is displayed. The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12".

  When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...

• How long does the die cutting blade/knife and wear strip last? (LX610)

  Digital Die-Cutting Blade Life The longevity of the blades depends on the type of material being used; how much material was cut; and the number of times the blades scored through the liner coming into contact with the wear strip. Blades can last up ...

• What is the difference between Kiss Cut vs Digital Die-cut vs Pre Die-cut? (LX600-LX610-LX910-LX2000-LX500)

• New Liner/Top Surface for Digital Die Cutting Stock listed below. (LX610)

  Notice: Our old manufacturer, Avery, no longer makes the previous liner/backing paper or high gloss paper label stock, so unfortunately, we were forced to change to a new material. We tried our best to offer a similar material, but some differences ...