How do I replace the Cookie Sensor Board? (Eddie)

• Related Articles

• Error Message: Remove Cookie/Cookie was left in the printer after power up. However, there is no cookie present on the platform. (Eddie)

  If you receive this error after powering up Eddie, follow the steps below. If you receive this error in the middle of printing, it probably means that Eddie needed to restart for some reason, and since it was in the middle of printing when it ...

• Cookie Too Tall Error (Eddie)

  If you receive this error it means that the cookie is short enough to fit inside the Eddie print area but too tall for the cookie height sensor to see over. Eddie can't get a good reading on the top of the cookie so the proper print head height can ...

• The Top of Cookie Lift Offset setting explained (Eddie).

  The primary purpose of the Top of Cookie Lift Offset is to make your images crisper. It is not necessarily used to prevent your print head from hitting the cookie. Dirt, debris, or ink overspray may be on your encoder strip, cookie sensor, or both. ...

• The cookie does not print centered. (Eddie).

  A. Try this First Your cookie MUST be touching two triangle spacers. When using the carousel, Eddie will center print images on your cookies automatically but only if your cookie is touching two triangle spacers. (round spacer on earlier models). ...

• How to print Red with Eddie Edible Ink Printer.

  Update 09-21-22. A new cartridge with new magenta that prints a better red is now available. SKU 053507. To order select New Magenta from the menu on this page. If you have the original 053498 Cartridge you can still use these instructions to get a ...