How do I load label stock, adjust the gap sensor, change print cartridges or change a print head (LX900 Videos)?

• Related Articles

• Top of Form (Vertical) Alignment: Gap Sensing Error. Label stock is not loading. Label alignment is printing vertically offset. There is a white line/gap at the top or bottom of my label. The image is printing too far down the label or too early (LX Series).

  If labels are printing horizontally offset, try the solutions in this article: Labels are printing horizontally offset (left to right). The image is printing too far to the left or right. The LX series printer decides where to start printing by ...

• How do I adjust the Gap Sensor position on my LX910 or LX3000.

  Please watch this video demonstration. ​ The gap sensor is used to sense the start of each label so the printer knows where to start printing. With most square or rectangular media the default position of 0.3" from the left edge is sufficient to ...

• How do I correctly load the label stock to avoid feeding and printed image alignment offset problems? (LX Series)

  Incorrect loading of the label stock is the number one reason for horizontally or vertically offset images and a variety of other feeding problems. Below is a top view of the printer with the cover open. There are several main areas to watch for when ...

• How many labels per cartridge can I print? How can I calculate ink cost per label in Print Hub? (LX Series Printers)

  The cost estimator is found under the queue section on the first tab of the Print Hub on PC and on the first tab of the Config Utility on Mac. On PC the last five job costs are stored in the list. Each job will show the cost per label based on the ...

• “TOF Error” is displayed in the status monitor. Label stock will not load automatically or printer does not detect the label stock. (LX2000).

  The LX2000 is not properly sensing the gaps between the labels on your label roll. (TOF = Top of Form) Check the following settings:  Try pressing the "Resume/Feed" button on the front of the printer. If the error continues, press the “Cancel” button ...