How do I clean or replace the output cutter blade on my LX Series printer? (LX910, LX2000, LX3000)
The video below shows the process for the LX2000. However, the mechanism is the same for LX910, LX2000, and LX3000.
Tools Required: T10 Torx driver
You may also need to clean the cutter plate with isopropyl alcohol and a Q-tip.
Article ID: 092121
Related Articles
Can I use the output cross cutter to cut the final height of my labels? (LX500, LX600, LX610, LX910, LX2000, LX3000)
Using the output cutter to cut the height of the label is not recommended. The output cutter was designed to cut a printed section of labels from the printer after it is complete. It typically cuts through liner only in the gaps between the labels. ...How do I use the Cleaning Card to clean my output cross-cut media cutter. (LX600, LX610, LX910, LX3000, LX500)
Video Demonstration https://youtu.be/0ibFKY52kho PC Instructions Note: This cleaning procedure works best when done regularly. If your cutter gets too full of adhesive and other debris, it may need more through cleaning. Follow these articles: LX600, ...Cutter Stall Error (LX600-LX610)
The cutter referred to by this error message is the output cutter located at the front of the printer. This is a pizza wheel-style cutting disc that completely cuts through the label/media at the end of the job or at the end of every page, depending ...IP60 Video: Clean or Replace the cutter blade disc
The Primera Impressa IP60 can print on a wide variety of materials. If you choose to print on magnetic material the cutting blade that cuts every photo can accumulate waste magnetic material which will eventually prevent proper cutting. Replacement ...Discs are printing with poor quality or missing colors. (4100 Series)
Try the following solutions: 1. Change the Cartridge. Check your cartridge levels. If the lowest percentage color corresponds to a missing color in your print, replace that cartridge. Even if the software reports that the cartridge has 30% ink ...