How do I calibrate the loop sensor on the LX900?

• Related Articles

• “TOF Error” is displayed in the status monitor. Label stock will not load automatically or printer does not detect the label stock. (LX2000).

  The LX2000 is not properly sensing the gaps between the labels on your label roll. (TOF = Top of Form) Check the following settings:  Try pressing the "Resume/Feed" button on the front of the printer. If the error continues, press the “Cancel” button ...

• My label printers skips labels between prints, feeds out blank labels or is printing over the same place. (LX500, LX600, LX610, LX910, LX2000, LX3000).

  The printer will skip one label before printing for the first time after loading a new roll of label stock. This is to prevent jamming of labels and cannot be disabled. The printer should not skip labels between consecutive print jobs. If the printer ...

• How do I adjust the Gap Sensor position on my LX910 or LX3000.

  Please watch this video demonstration. ​ The gap sensor is used to sense the start of each label so the printer knows where to start printing. With most square or rectangular media the default position of 0.3" from the left edge is sufficient to ...

• PTPublisher for Mac: How to calibrate printer and drive picking depth positions for a Disc Publisher. Fix Error: Multiple discs were placed in the printer or drive tray

  1. Open Ptpublisher. 2. Once open at the top next to the apple logo select Ptpublisher then select Calibrate robot... 3. Click Calibrate Disc in Printer if you are getting an error that multiple discs were placed in the printer tray but only one was ...

• Repeating sections of blurry printing - Inconsistent TOF alignment - Printing over on the same label using pre-die-cut labels on (LX600/LX610)

  Issue: Pre Die-cut labels printed on the LX600 or LX610 has inconsistent Top of Form (Vertical) alignment or print over and over on the same label or have repeating sections of blurry printing. The smaller the size down to the minimum of 2", the more ...