How can I apply labels to empty Bag or odd shaped containers using my AP550? How to apply labels more accurately using support fixtures or a jig (AP550)?
The platform of the AP550 applicator is meant
to support specialized fixtures or placement helper jigs that make it easier to quickly
place the container and more accurately place the label. The fixtures can be made out of wood, moldable plastic, polyethylene foam, cardboard, or even 3D printed plastic to provide repeatability, accuracy, and interchangeability.
1. Toolbox organizing foam works very well for this purpose. Trace the outline of your container or bag and then cut it with a utility knife. This foam has multiple layers. You cut the top layer and place it on the bottom layers, then adhere them together by removing the adhesive protection sheet. If you are applying it to flat bags, the top layer of the foam should be very thin, just enough to hold the bag in
place.
2. Moldable Plastic Pellets. These plastic pellets can be melted at a low temperature in a container where you can press your product into the plastic to form a depression that will hold your product firmly for label application.
- Moldable Plastic Pellets (Search Amazon for "Moldable Plastic Pellets" if this link no longer works.)
- This video explains the process of using these pellets.
Primera no longer sells pellets or metal containers shown in the video!
3. 3D Printed Fixture. Use a simple free design program such as Tinkercad to design a jig to hold your product. Use a 3D printer to print your fixture/Jig.
Change between different sizes. If you have multiple different containers or
bag sizes you can easily swap out the fixtures.
Attach the fixture to the platform. If you
only apply to one container size you can attach the fixture to the platform
using the slots in the bottom of the container. Place a washer on a screw and affix the fixture/jig to the platform from the bottom.
Article ID: 020923
Related Articles
My labels have bubbles or wrinkles. How can I resolve this? AP360/AP362/AP380
This issue can be caused by one of the following: 1. The container is not completely round, not smooth or has bumps or ridges. See this article on tapered containers. 2. The labels are applied crooked due to incorrect setup. See this article. 3. The ...Can I apply labels to a tapered container (AP360-AP362-AP380)
Applying labels to tapered containers by angling the container idler roller at the front of the machine is possible. Containers with a 5°-or-less taper per side have a chance of applying labels square to the container using an AP360/362/AP380 with ...LX3000 - Empty Ink Error but Ink is not Empty. PrintHub Software or Mac Config Utility says my ink tanks are empty but I can see there is still ink left.
Error explanation: Ink usage is calculated by the software, not a physical sensor(gas gauge). Between printer uses, some ink bleeds out of the ink lines and back into the tank. When you start printing again, it takes some time for the ink to make its ...Can I apply labels to a Ziplock or Polygrip bag? (PL400)
Thin zip lock or Polygrip bags can work in the PL400. The bag pictured below successfully triggered the sensors and applied the label shown. Here are some important tips. Feed the bag zipper side first (upside down). This provides some rigidity ...How should I store the cartridge for my AP-Code Date coder when it is not being used?
To prevent ink evaporation, when the cartridges is not being used, you should remove it from the printer, cap it using the included cartridge garage and store it in the zip-locked foil bag that it came with. For best results, follow this procedure ...