Freddie/Eddie Power Requirements
Note: The Freddie Power Supply is different than the Eddie Power Supply despite their similar visual appearance. The Eddie Power Supply will not work for the Freddie.
Freddie Power:
Input: 100-240v
Output: 12v 5.0 Amps 60 watts
Eddie Power:
Input: 100-240v
Output: 12v 3.0 Amps 36 watts
Using an Eddie Power Supply on a Freddie will cause a variety of errors at various points during operation. Unfortunately, no clear error is displayed. For this reason the Freddie power supply will have a label around the barrel. You can also compare the specifications as shown below.
Article ID: 101525b
Related Articles
Error Message: Remove Cookie/Cookie was left in the printer after power up. However, there is no cookie/custom tray present on the platform. (Eddie)
If you receive this error after powering up Eddie, follow the steps below. If you receive this error in the middle of printing, it probably means that Eddie needed to restart for some reason, and since it was in the middle of printing when it ...Can I print wirelessly to my Primera Printer? (LX3000, LX4000 and Eddie)
The Eddie, LX3000, LX4000 or Catalyst can be used out of the box with a USB connection or Ethernet connection. You can purchase a BrosTrend Wifi Range Extender with an Ethernet port to connect the printer to a wireless network. You can then print to ...Does the CX1200 or FX1200 have any special power requirements?
Does the CX1200 or FX1200 have any special power requirements? The CX1200 and FX1200 can be plugged into standard 120 volt outlets on the same 15 amp circuit. Peak amperage is 11.56 amps if both are running together. If additional equipment will be ...What are the minimum computer specifications required to print to my Eddie printer?
PC - Specifications/Requirements Ensure the PC specs meet or exceed the following specifications. Windows 8 / 10 / 11 Compatible (32bit/64bit) Intel or AMD Processor (ARM Snapdragon processors are not supported) For Mac OS 10.11 or higher. 8 GB of ...How to enable Manual Feed Mode for oversized or irregular shaped cookies (Eddie).
Manual feed mode allows you to load cookies by hand directly to the print platform. This can be used for oversized or irregular shaped cookies that don't fit well on the carousel platter. To enable manual feed: 1. Update to the latest firmware 1.25 ...