Error Message: Paper Jam 200.69, 200.72 or 200.75 (CX1200)
This type of paper jam indicates that the registration motor is failing. This is generally caused by adhesive building up disabling the gears that the registration motor controls. These gears are not easily accessible but they can be cleaned by saturating the back edge of a two foot piece of paper with adhesive remover and shimming it back and forth at the paper path’s entrance. See picture below. Remove the cartrdiges and ITU to access this area. You can use Goo Gone, Goof Off or 3M Adhesive Remover. Finally, clean the paper guides and the white MPfeeder door friction buckler as well. Refer to the instructions below.
Article ID: 60620
Related Articles
Paper Out Error is displayed in PrintHub (LX610).
Normally, the paper out error indicates that you are at the end of a roll of label stock. You will need to load another roll of media in the printer. If the media is loaded, and the error appears when you send at print, or the error appears at ...Paper Jam Error 250.15 - MP Feeder Door (CX1200)
Paper Jam Error 250.15 MP Feeder Door (CX1200) A. This error indicates a paper jam at the MP Feeder Door. Please clean the following parts on the door with isopropyl alcohol and a lint-free cloth. (See picture below) Feed Roller (Replacements can ...CX1200 displays Paper Jam Error 200.28 in A,B,D - or 202.30 in D, K, L.
200.28 A, B, D = Input sensor tripped. Focus on the left side of the printer. 202.30 D, K, L = Output (fuser) sensor tripped. Focus on the right side of the printer. There are many different paper sensors in the CX1200. Either of these errors means ...The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12". When the print is sent, Gap Sensing Error is displayed or Non Digital Die-Cut Error message is displayed
When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...Unable to feed paper / media / stock on initial load. Printer will not grab the paper (LX610).
Issue. Wear strip is too thick, too wide or improperly installed which causes it to protrude too high into the paper path. This will prevent the label stock from feeding into the printer. It gets stuck right before the wear strip. If the wear ...