Error: Alignment Needed displayed in Primera PrintHub for IP60 Photo Printer.

1. To send the alignment print, open the printer preferences from Windows or your printing application.  

2. Click the Properties button next to Launch PrinHub.

3. Click the Alignment Icon.

4. Choose Send Alignment.

Note: If you open Print Hub through the normal shortcut, the Send Alignment button will not be enabled.  You may also run Print Hub as Admin by right-clicking the launch shortcut and choosing "Run as Admin"

Article ID: 060826

• Related Articles

• How do I stop Primera PrintHub from starting when I print to the IP60

  Sometimes it may be necessary to prevent PrintHub from launching so it doesn’t pop up in front of your Photo Booth software.  To do this open the printer driver preferences. Search for Printer in the Windows search bar.  Select Printers and ...

• Error: The printer couldn't print <Document Name>. Unable to connect to Printer. Printer in Error State. Generic Microsoft Windows Error Printing on Edible Ink Printer. (Eddie) (PC Only).

  1. Connect the USB, connect power, and switch the printer on. 2. Print Hub. "The printer couldn't print <Document Name>" This generic Microsoft Windows error may occur after a Windows Update. A more specific error may be displayed in the Primera ...

• Top of Form (Vertical) Alignment: Gap Sensing Error. Label stock is not loading. Label alignment is printing vertically offset. There is a white line/gap at the top or bottom of my label. The image is printing too far down the label or too early (LX Series).

  If labels are printing horizontally offset, try the solutions in this article: Labels are printing horizontally offset (left to right). The image is printing too far to the left or right. The LX series printer decides where to start printing by ...

• How do I create a label template in Bartender? (LX Series Printer)

  When you open BarTender you will be given the choice to select an existing label or create a new one using a wizard. Use the following instructions as a guide through the wizard setup process. 1. Choose "Start a new BarTender document..." 2.      ...

• My LX610 or LX600 is skipping, slipping, printing over on the same spot or printing out of alignment left to right. Feed Stall. (LX610-LX600)

  There are several reasons for skipping labels or a feed stall error on the LX-Series printers. A full article explaining all of the possibilities can be found here. See below for the LX600/LX610 specific reasons. Create Loop. Check the create loop ...