Eddie resets in the middle of a long manual mode print job (Eddie).
In manual mode, Eddie waits for you to press the button on the printer before retracting the cookie for printing. If you wait too long before pressing the button because you were interrupted for some reason or another, Eddie may reset and cancel your print job. Eddie resets any time it receives a partial print. Your PC may have gone to sleep while waiting for the next print job to be initiated. This may corrupt the print job waiting in the queue and cause a partial print. Check your PC Power and Sleep settings if you may be interrupted. Increase the sleep time or turn it off completely (Set to Never).
Article ID 012522
Related Articles
How to enable Manual Feed Mode for oversized or irregular shaped cookies (Eddie).
Manual feed mode allows you to load cookies by hand directly to the print platform. This can be used for oversized or irregular shaped cookies that don't fit well on the carousel platter. To enable manual feed: 1. Update to the latest firmware 1.25 ...What size/type cookies can I print to with my Eddie?
The cookie size and shape you can print depends on whether or not you are using the carousel and other settings. You have more flexibility in Manual Mode/Single Cookie mode. There are several modes available. See the specifications for each below. 1. ...LX Series Printer prints a partial label and restarts/resets in the middle of a job. (LX910, LX3000)
Sometimes the printer will restart if it encounters an error or an interruption in the data flow from the computer over the USB cable. It can be hard to realize that the printer is restarting if you don't see it happen. Instead at the end of the job, ...How do I use my DTM Manual Feed Trays with the Eddie?
If you purchased manual plastic feed tray templates for your Eddie from DTM Print in Germany please visit the link below. You will need to download BarTender or NiceLabel Templates to use them. Also, watch the video for instructions. ...Eddie stops, pauses or resets in the middle of printing the cookie causing it to smash cookies taller than 0.625" into the top wall of the printer during the start-up routine. (Eddie)
Sometimes Eddie will restart if it encounters an error. It often causes issues if this happens because you have a cookie on the tray. (or Cookie + Custom Tray) So when it starts up, it either displays an error OR it will smash the cookie into the top ...