CX1200 Print Specificatons for Fixed Die Cutters.
CX1200 Print Specificatons for Fixed Die Cutters.
Important Note: Because of the .125" (3.17mm) gap between pages which is required by the printer, most existing flexible or hard tooled dies will not work with the printed output of the CX1200. For this reason you will need to create new dies for output printed on this printer. The one exception to this would be if your die cutter can reregister at least .125" (3.17mm). Most hard tooled die cutters that do not lift the die off the web can not reregister more than 1mm.
Note: None of the above specifications apply to XY plotter cutters.
Article ID: 44946Related Articles
The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12". When the print is sent, Gap Sensing Error is displayed or Non Digital Die-Cut Error message is displayed
When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...What size/type cookies can I print to with my Eddie?
The cookie size and shape you can print depends on whether or not you are using the carousel and other settings. You have more flexibility in Manual Mode/Single Cookie mode. There are several modes available. See the specifications for each below. 1. ...The LX3000/LX4000 Print Head is printing with Poor Quality, Banding, Streaks, or Missing Colors.
You may need to replace your print head. The nozzles can wear out over time. Tip! Leave the printer powered on when it is not in use to maintain cartridge readiness! 1. Clean / Test Print. Print the Clean/Test Print described in this article. Send us ...Can I open the print head lid on my LX3000/LX4000?
Occasionally you may need to remove the printhead to clean the nozzles. Use the instructions in the video below. You may open and close the lid up to 8 times before the print head will lose its prime and need to be replaced. Each time you open the ...Print Alignment Not Available for Digital Die-Cut message appears on the alignment screen in PrintHub. (LX610 Only)
Print alignment is not available on the LX610 by design because there are no die-cut labels that can be aligned to a print. Instead, the cut line must be aligned to wherever the printing occurs. Cut alignment is calibrated at the factory. However, ...