Can you use a cookie scraper to remove icing from a cookie to reuse it and try icing again.
We do not recommend using a cookie scraper since a small amount of white icing residue is left behind on the cookie surface. This makes it difficult for the vision system to properly detect the cookie. You may end up with an incomplete icing job or a failed calibration
Article ID 061925
Related Articles
Error Message: Remove Cookie/Cookie was left in the printer after power up. However, there is no cookie/custom tray present on the platform. (Eddie)
If you receive this error after powering up Eddie, follow the steps below. If you receive this error in the middle of printing, it probably means that Eddie needed to restart for some reason, and since it was in the middle of printing when it ...
Smaller diameter, thin or lighter cookies do not print, the image is overlapping itself, the image is not centered, or Cookie out error. (Eddie).
The reason for this is not always related to the size but instead, it has more to do with the weight. These cookies are lighter which can allow the cookie to move slightly as it is being scanned for size. If the cookie is too small or moves during ...
There is a label stuck or jammed in the feed area of my LX Series label printer. Unable to feed in Label Stock. How can I remove it and prevent it from happening again?
If you are unable to feed in new label stock, you may have dust or debris blocking the stock sensor or part of a label stuck inside. Unexplained missing labels on the roll could actually be stuck inside the machine. If you don't think there is a ...
What size/type cookies can I print to with my Eddie?
The cookie size and shape you can print depends on whether or not you are using the carousel and other settings. You have more flexibility in Manual Mode/Single Cookie mode. There are several modes available. See the specifications for each below. 1. ...
Cookie Too Tall Error (Eddie)
If you receive this error it means that the cookie is short enough to fit inside the Eddie print area but too tall for the cookie height sensor to see over. Eddie can't get a good reading on the top of the cookie so the proper print head height can ...