Can I use my digitally die cut label roll on an applicator such as the AP360, AP362 or AP550 (LX610)?
Unfortunately, it is not possible to use a digitally die-cut roll on an applicator. Even with the waste matrix removed, and setting the machine in half-speed mode, the liner is too thick to pull through the applicator. This applies to the following label stock:
- Estate Matte - SKU 057214
- Premium Gloss Paper - SKU 057211
- High Gloss BOPP - SKU 057216
- Matte BOPP 057212
Article ID 042121
Related Articles
How to Create A Custom Label Order
1. Go to https://www.primera.com/customlabel/generate/label/ 2. Select your printer type. 3. Then click Select Materials. View the material guide for more information on each material type of look at the pictures below. Premium Gloss Matte BOPP High ...
There is a label stuck or jammed in the feed area of my LX Series label printer. How can I remove it and prevent it from happening again?
A. Removal: Usually, it is necessary to disassemble part of the printer to remove the stuck label. This means the unit will need to come to Primera for factory service. However, there are ways to remove these labels without taking apart the ...
The smart Chip in my Primera LX610 media is defective. When inserted the media is not recognized as Digital Die-cut Media. The media feeds forward and back 12". When the print is sent, Gap Sensing Error is displayed or Non Digital Die-Cut Error message is displayed
When you insert digital die-cut media you should see an icon in the upper left corner of print-hub indicating you have Digital Die-Cut Media and a corresponding percentage remaining. If you do not see the icon make sure your media is digital die-cut ...
How do I use BarTender 2021 to add cut lines to a print template design (LX610 or Catalyst).
Within BarTender, any shape can be converted to a cutline that your LX610 or Catalyst printer can cut. You must use BarTender version 2021 Ultralite, Professional, or Enterprise. 1. Click the shape icon on the toolbar. 2. Drag the shape ...
The last few labels of my roll are wasted. Out of Paper error is displayed but there are still labels remaining. Is there any way to print on the last labels of the roll. (LX600, LX610, LX900, LX910, LX2000, LX1000, IP60)
By design the last 12-18” will be wasted because the printer no longer detects a loop under the roll, or the chip on the LX600/610/ip60 detects the end of the roll. We must stop before the last labels are fed through to prevent the tape or strong ...