Can I use containers with a lip or a lid on the top which sticks out further than the container? (AP360 or AP362).

The AP362 has a notch in the container drive roller and container idler roller.  This notch is intended to accommodate a lip or lid that sticks out at the top of the container.  That lip/lid cannot extend more than 3mm from the rest of the container or be taller than 16mm.  The notches are on both sides of the rollers to accommodate either orientation.  If the notches are used the maximum height of the container cannot exceed 220mm (8.66")

• Related Articles

• Labels are not applied to lip balm, chap stick or small diameter containers. The label either goes over the container or pushes the container off the rollers. (AP360/AP362)

  Since these containers are so small they can be challenging to apply labels to. They are within the applicator specifications but they work best with certain label stock. Tips: More Pressure. Rest your hand on top of the container pressure arm as you ...

• How should I store the cartridge for my AP-Code Date coder when it is not being used?

  To prevent ink evaporation, when the cartridges is not being used, you should remove it from the printer, cap it using the included cartridge garage and store it in the zip-locked foil bag that it came with. For best results, follow this procedure ...

• Labels are not sticking to the containers. The label adhesive is lifting off the containers some time after application.

  If your label does not stick to the container immediately or lifts off after some time, consider these solutions: Label Stock Adhesive. All of Primera's label stock has Acrylic based adhesive. Most of it has the same adhesive strength. Each label ...

• Can I apply labels to a tapered container (AP360-AP362)

  Applying labels to tapered containers by angling the container idler roller at the front of the machine is possible.  Containers with a 5°-or-less taper per side have a chance of applying labels square to the container using an AP360/362 with the ...

• The AP-Code Date Coder is not printing. Status is Ready, the container moves, the label is applied but nothing is printed.

  1. Ensure the Roller Track Wheel is installed properly so that it touches the liner drive roller. Watch the Printer Status screen. When you press the foot switch, the Printer State should change to "Printing". If the status remains on Ready, it means ...