Cam Lifter Stall Error (LX610)
This error indicates a problem with the camshaft use to raise and lower the sidetrack rollers used for digital die-cutting. The printer needs repair. Please contact support to set up a repair.
If the error is intermittent you can try oiling the bearings using the instructions attached.
Article ID: 021621
Related Articles
Cutter Stall Error (LX600-LX610)
The cutter referred to by this error message is the output cutter located at the front of the printer. This is a pizza wheel-style cutting disc that completely cuts through the label/media at the end of the job or at the end of every page, depending ...
Carrier Stall Error (IP60, LX600, LX610, LX910 or LX3000)
This error indicates that the printer is having trouble moving the cartridge carrier from side to side. Check the following: 1. Check for obstructions in the path of the cartridge carrier. Look for paper/media that has jammed or bubbled up and is ...
LX 2000/ LX 1000 - Error Message: failed printhead, printfailure impropershutdown
LX2000 - Error Message: failed printhead, print failure improper shutdown Solution 1: Perform a print head alignment described below. This will clear and resolve the mentioned error message and allow you to print. Solution 2: Install a new print ...
Feed Stall Error (Eddie).
The feed stall error means that the lower arm of the cookie platform/tongue is hitting the crumb catcher. There are a couple of reasons for this. 1. Press Load/Unload Button. If the error occurs right after the printer starts up, either press the ...
Carrier Stall Error (Eddie)
This error indicates the printer has trouble moving the cartridge carrier from side to side. Check the following: 1. Check for obstructions in the path of the cartridge carrier. Most often, this will be caused by a cookie blocking the path of the ...