How do I calculate the distances for Two-Label Mode - Front & Back (AP362)?

• Related Articles

• How do I use Lamination Mode on the LX610?

  Enable "Lamination Mode" in PrintHub and Config Utility(Mac). This setting will convert Matte BOPP or Gloss BOPP digital die-cut material into waterproof labels. With lamination, Premium Gloss stock will become highly water-resistant to surface water ...

• Can I use my digitally die cut label roll on an applicator such as the AP360, AP362 or AP550 (LX610)?

  Unfortunately, it is not possible to use a digitally die-cut roll on an applicator. Even with the waste matrix removed, and setting the machine in half-speed mode, the liner is too thick to pull through the applicator. This applies to the following ...

• How to Create A Custom Label Order

  1. Go to https://www.primera.com/customlabel/generate/label/ 2. Select your printer type. 3. Then click Select Materials. View the material guide for more information on each material type of look at the pictures below. Premium Gloss Matte BOPP High ...

• There is a label stuck or jammed in the feed area of my LX Series label printer. How can I remove it and prevent it from happening again?

  A. Removal: Usually, it is necessary to disassemble part of the printer to remove the stuck label.  This means the unit will need to come to Primera for factory service.  However, there are ways to remove these labels without taking apart the ...

• How do I print a two page (front-back) label using BarTender Ultralite? (LX Series Label Printer)

  The instructions below are for two page labels where both the first and second page are the same size.  Each have separate designs.  This would typically be used for front-back labels on a container.  For different sized front and back labels you ...