After each disc that I laminate, the Power light starts flashing. If I open and close the cover, I can laminate another disc but the power light starts flashing again.

• Related Articles

• Can I operate my Bravo with its cover open?

    Can I operate my Bravo with its cover open? No. The cover must be closed for the robotics to move. This is a required safety feature. However, there is a way to open the lid and watch the Bravo if you need to observe the robotic movements for ...

• Labels are fed through the printer 24 inches at a time resulting in a flashing power LED light.

    Labels are fed through the printer 24 inches at a time resulting in a flashing power LED light. The LX400 is not properly sensing your label stock. Check the following settings: SENSOR TYPE SETTING. Make sure the sensor type setting in the printer ...

• The pause light is flashing when the LX800 starts.

  The pause light is flashing when the LX800 starts. This indicates that the label stock is not installed.  Label stock must be installed on the roll arm and fed into the printer.Article ID: 44883

• The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing.

    Article # 207963 - The Bravo's robotic arm places a disc into the printer tray, retracts the tray, but immediately ejects the tray without printing. The left (cartridge) light starts flashing. To fix this issue, Run the Calibrate Last Disc (PC) or ...

• The pause light on the LX800/LX810/LX900 starts flashing when I try to print. I receive the message "It appears the label stock may be empty."

  The pause light on the LX800/LX810/LX900 starts flashing when I try to print. I receive the message "It appears the label stock may be empty." If you receive this message, or you see this flashing light indicator you may be out of label stock or ...